Crossbars for the first generation Toyota C-HR AX10 produced from 2016 to 2023. Vehicles of this generation come from the factory with a bare roof, so the choice of setup depends on your preferred bar profile and planned cargo.
The first generation C-HR uses a bare roof mounting type. The rack feet attach to the upper body frame in the door area using specially shaped steel clamps.
Thoroughly clean the paint in the contact areas before each installation. Dust and small debris under the rubber foot pads could scratch the paint surface due to vibrations while driving.
The AX10 generation was produced until 2023, when it was replaced by the new H2 generation. If your vehicle was manufactured in 2023, verify the exact model code in your vehicle registration document, as mounting kits for different generations may not be interchangeable.
For the newer vehicle generation, go to the offer for the Toyota C-HR H2 model.
The specific silhouette of the C-HR with a sloping rear line and a prominent roof spoiler requires attention when choosing a roof box. A long box may collide with the spoiler when the tailgate is fully opened, so measure the space from the front crossbar to the edge of the open tailgate in advance. The total roof load limit must include the weight of the cargo, the empty box, and the crossbars themselves. You can find the maximum permitted roof load in the vehicle manual.
Verify the exact composition of individual sets directly in the product detail and choose a suitable setup. The list of all generations is shown in the Toyota C-HR category and the full offer for this brand can be found under Toyota.
12 sets
